American Gear Manufacturers Association
VIAF ID: 148357442 ( Corporate )
Permalink: http://viaf.org/viaf/148357442
Preferred Forms
-
- 110 2 _ ‡a American Gear Manufacturers Association
-
- 110 2 _ ‡a American Gear Manufacturers Association
- 110 2 _ ‡a American Gear Manufacturers Association
- 110 2 _ ‡a American Gear Manufacturers Association
-
- 110 2 _ ‡a American Gear Manufacturers Association
-
4xx's: Alternate Name Forms (10)
5xx's: Related Names (1)
- 551 _ _ ‡a USA
Works
Title | Sources |
---|---|
20-degree involute fine-pitch system : for spur and helical gears | |
AGMA directory. | |
AGMA paper | |
AGMA standard | |
Allowable loads and speeds | |
Allowable torsional and bending stresses | |
American Gear Manufacturers Association directory | |
Appearance of gear teeth : terminology of wear and failure | |
Application classification for gearmotors | |
Cast iron gear blanks | |
Design for fine-pitch worm gearing | |
Design manual for enclosed epicyclic gear drives | |
The evolution of the gear art | |
Fine-pitch straight bevel gears | |
For cylindrical-worm gear speed reducers | |
For surface durability of double enveloping-worm gearing | |
Fundamental rating factors and calculation methods for involute spur and helical gear teeth | |
Gear inspection and tolerances section 5-master gears | |
Gear materials-steel | |
Gearmotor output speeds | |
High speed helical & herringbone gear units | |
Inspection of fine-pitch gears | |
Keyways for holes in gears for general industrial practice | |
Letter symbols for gear engineering ; Abbreviations for gear engineering | |
Lubrication of enclosed and open gearing | |
Mechanisms of gear tooth failures | |
Method for specifying the geometry of spur and helical gears | |
Rating the pitting resistance and bending strength of generated straight bevel, zerol bevel and spiral bevel gear teeth : American national standard | |
A rational procedure for the preliminary design of minimum volume gears | |
Recommended practice ... c19--. | |
Single-thread hobs | |
Standard for design and specifications of gearboxes for wind turbines | |
Surface durability rating for helical and herringbone gears | |
Tentative AGMA information sheet : for strength of spur, helical, herringbone and bevel gear teeth | |
Terms, definitions and illustrations |